GTS Elevator Industry and Trading Ltd. Co.
SITE MAP | CONTACT | HOME 
 
   Controller

Smart Elevators...

The elevators which are used since a century for carrying passengers
became smart with the development of electronic and information
technologies.

CONTROLLER is the most important feature of the elevators which
exists in varieties, but equivalent in values from the standpoint of
mechanical and architectural design.

Nowadays; only reliable, safe, orderly, speedy and
SMART elevators, in other words, intelligent elevators
can meet the demand.

The most popular, reliable and developed worldwide products
are used in the operation and control of GTS elevators.

These products are developed by Mitsubishi
Electric which is distributed by us.

  • Mitsubishi PLC's
  • Mitsubishi FREQUENCY INVERTER's
  • Mitsubishi SWITCH AND CONTACTOR's

 

 

 

 

 





 

 

 

 

 

MITSUBISHI PLC'S

Mitsubishi PLC's (Programmable Logic Controllers) are the most perfect products which enable conversion of human logic into industrial application...

GTS is one of the small group in the world that can develop its own elevator software, develop a technology higher than the norms specified by the international standardization organizations by combining this with PLC.

Why MITSUBISHI PLC and why GTS Controller ?

Because;

  • There are more than 5 million Mitsubishi PLC's operating through out the world.
  • The Leading PLC producer in the world is MITSUBISHI.
  • The highest speed in the world is obtained by PLC; 0,08 us/logic control.
  • Program memory facility of 16000 step
  • There is a possibility for 256 units of I/O.
  • There is a remote control possibility.
  • There is serial communication-network possibility, with RS 232, RS 485, RS 422.
  • There is possibility of using IT technologies such as Internet, e-mail and SMS.

Our criteria for the products used in the operation and control of the elevators is not limited to quality. The environmental sensitiveness, easy and expandable handling by the user, possessing ISO9000 and CE quality certificates, orderly controller of the product , are also considered as basic criteria.

Is a good CONTROLLER sufficient for a good Elevator?

As all other elevator companies, we also wish that the few seconds you spend in the elevator would give you pleasure. Therefore, we offer all our passengers, from the moment they step into the cab, safe, silent, vibration free, speedy and comfortable lift. And while offering this, we use products which do not cause electrical pollution and enable energy saving.

MITSUBISHI FREQUENCY INVERTER'S

  • Perfect landing in the floors-Reduced failure to Nil, +/- 0mm
  • Maximum moment by digital vector control even in zero speed.
  • Perfect response speed (200 rad/sec)
  • Wide speed range (1:1500)

Elevator DOOR Speed Control

The most frequent failure detected in the elevators from the standpoint of passenger safety, is the door of the elevator.

GTS, as always in the main engine drive, also uses Mitsubishi Inverter in the control of gate engine speed.

Consequence;

  • To durability of the door elements are increased two folds, provide silent, orderly and fast door opening.
  • 3 Phase asynchronous engine drive possibility through frequency inverter drawn by mono-phase feed.
  • Low cabling cost-Easy detection of failure-Perfect electrical protection.


 
     COMPONENTS
     CONTROLLER
     CAR
     DOOR
     DRIVE
     FIXTURE